Analog Integrated Circuits & Lab
Interfacing a Transducer to an Analog-to-Digital Converter and Interfacing Digital-to-Analog Converters to Loads
The purpose of this lab is to allow students to gain experience constructing Digital to Analog Converters in Multisim. Students will extend the concepts learned in the module and homework to build an 8-Bit DAC. Several binary inputs and the associated analog output values measured with a virtual digital multimeter will be captured in screenshots.
Watch the video Week 5 – Op Amp DAC Circuit
Determine the values of all the remaining seven resistors and fill in the table 1.
Table1:
Resistors
Values
R1
1K Ω
R2
R3
R4
R5
R6
R7
R8
3.Recall the binary to decimal conversion and fill the table below:
Bits
Binary Input
Decimal conversion
MSB
(S1)
1000 0000
S2
S3
S4
S5
S6
S7
LSB
(S8)
0000 0001
Construct an 8-bit binary weighted DAC in Multisim and measure the output voltage Vout using the multimeter and record the computed gain below.
Table2:
Bits
Binary Input
Vin
Rn
(n = 1,2,3,4,5,6,7,8)
RF
Output Voltage (Vout)
Voltage Gain (Av)
MSB
(S1)
1000 0000
S2
S3
S4
S5
S6
S7
LSB
(S8)
0000 0001
Take the screenshots of Vout measurements for the input/output combination for each of the above 8-bits.
Answer the following questions:
Determine the approximate value of RF which results in accurate digital to analog conversion.
Write the expression for Vout in terms of Vin, RF and R for each bit. Also, express Vout in terms of all 8 input voltages.
Starting from the least significant bit to the most significant bit, what is the effect of feedback resistance on the output voltage?
From your measurements, does increase in the digital value result in increase in analog value? Please explain.
Is the voltage gain of the op Amp different for each bit? Please explain why?
Create a new word document called “Lab5_StudentID.docx” with your GID substituted into the file name.
Verify all calculations from analysis and measurements from simulations. Save the results along with the table and paste the screen captures in the word document. Make sure to answer the questions.
Upload file “Lab5_StudentID” in Blackboard.
“WE’VE HAD A GOOD SUCCESS RATE ON THIS ASSIGNMENT. PLACE THIS ORDER OR A SIMILAR ORDER WITH HOMEWORK AIDER AND GET AN AMAZING DISCOUNT”
The post W5 Lab “Interfacing a Transducer to an Analog-to-Digital Converter and Interfacing Digital-to-Analog Converters to Loads” appeared first on Homeworkaider.
What Students Are Saying About Us
.......... Customer ID: 12*** | Rating: ⭐⭐⭐⭐⭐"Honestly, I was afraid to send my paper to you, but you proved you are a trustworthy service. My essay was done in less than a day, and I received a brilliant piece. I didn’t even believe it was my essay at first 🙂 Great job, thank you!"
.......... Customer ID: 11***| Rating: ⭐⭐⭐⭐⭐
"This company is the best there is. They saved me so many times, I cannot even keep count. Now I recommend it to all my friends, and none of them have complained about it. The writers here are excellent."
"Order a custom Paper on Similar Assignment at essayfount.com! No Plagiarism! Enjoy 20% Discount!"
